Install acoustic suppression kit on generator set.

Figure 5-17. Applications Kit Cable Harness Assembly Installation (Left Side)

Install acoustic suppression kit on generator set. (cont)

TM-9-6115-464-12 Wrench Impact Hydraulic Model MV-12-140T Manual
Page Navigation
274

ARMY TM 9-6115-464-12 AIR FORCE TO 35C2-3-445-1 NAVY NAVFAC P-8-624-12 (4) (5) (6) (7) (8) (9) (10) (11) (12) (13) (14) (15) (16) Slide bottom tray under generator set. Ensure weld nuts are positioned in down position. Weld nuts should be centered on fork lift tunnel holes. Raise bottom tray assembly, and install keepers, washers, and capscrews to secure on side of bottom tray assembly. (Refer to Figure 5-18.) Raise generator set, and remove 2"x4" blocks. Place a 1"x4" block under bottom tray assembly on other side and slowly lower generator set to push bottom tray assembly into position. Rubber must not bend or be allowed to tear loose when generator set is lowered. Install keepers, washers, and capscrews to secure the bottom tray assembly. (Refer to Figure 5-18.) Raise generator set, and remove 1"x4" block Lower generator set and remove lifting device. Do not allow side panel to fall from mounting members or set side panels on threaded studs Equipment damage could result if caution is not observed. Raise side panel skirt 90° and remove screws, capscrews, washers, keepers, and remove upper side panel skirt. (Refer to Figure 5-19). Attach lifting sling, and carefully raise and position side panel assembly on mounting member. Install three rubber washers, three flat- washers, and three locking nuts in bottom side panel. Ensure rubber flaps are flat against raditor and are pointed forward. Remove plastic plug and feed oil drain hose through side panel hole. Remove lifting sling from side panel. Repeat steps (9) thru (11) to install other side panel. Do not allow front lower panel to drop or set on ground. Damage to brackets could result. Equipment damage could result if caution is not observed. Position front lower panel assembly on generator set. Ensure top rubber flat is in raised position on radiator shell lip. Remove plastic plugs from rotolocks holes. Align male and female rotolocks and, using hex tool, turn rotolock to secure the front lower panel assembly. (Refer to Figure 5-19.) Install plastic plugs. Ensure mounting zee is below bottom tray assembly. Attach lifting strap to front top panel, and raise front top panel assembly on side panels. Ensure align- ment pins fit in holes for proper alignment. Remove plastic plugs from rotolockholes. Align male and female rotolocks and using hext tool, turn rotolock to secure the front top panel assembly. Remove lifting strap. (Refer to Figure 5-19.) Install plastic plugs. Position exhaust extention on engine exhaust. Install and tighten damp to secure the exhaust extension. Exhaust extension opening must be pointed down and must not interfere with other components later. Do not allow rear panel assembly to drop or set on ground. Damage to brack- ets could result. Equipment damage could result if caution is not observed. Attach lifting strap on rear panel assembly, and position rear panel assembly on generator set. En- sure alignment pins are in holes for proper alignment. Remove plastic plugs from rotolock holes. Align male and female rotolocks and, using hex tool, turn rotolocks to secure the rear panel assem- bly. Remove lifting strap. (Refer to Figure 5-19.) Install plastic plugs. Ensure mounting zee is below bottom tray assembly. NOTE Ensure lifting clevises are in the raised position before installing the roof panel assembly. 5-67

Privacy Statement
Press Release
Contact