ARMY TM 9-6115-464-12AIR FORCE TO 35C2-3-445-1NAVY NAVFAC P-8-624-12When troubleshooting the generator set with the acoustic suppression kit installed, schematics are stored behindthe document box mounted on the rear panel.a.Inspect the acoustic suppression kit components. (Refer to figure 2-15).(1)(2)(3)(4)Open doors and inspect for dirt, oil, water, or other foreign material.Inspect for defective seals, proper mounting, and loose, damaged, or missing components.Close doors and inspect for proper seal with enclosure.Inspect controls access door window for cracks, improper seal, or other damage.b. Service the acoustic suppression kit. (Refer to figure 2-15).(1) Carefully clean controls access door window with a mild cleaner.(2) Wipe controls access door window dry with a clean, soft cloth.(3) Clean all surfaces of the acoustic suppression kit with mild soap and water to remove deposits ofgrease, oil, or other foreign material. Allow to air dry.NOTEWhen acoustic suppression kit is installed, draining of cooling system and fuelsystem is difficult. Drain lines must be fabricated to drain fluids overboard.5-30 ACOUSTICSUPPRESSIONKITINSTALLATIONANDREMOVAL.Do not use hoisting equipment with maximum capacity less than 5,000pounds. Do not allow generator set to awing while suspended. Do not allowpersonnel under generator set or components of acoustic suppression kitwhen hoisted or lifted. Death or severe injury may result.a.Prepare generator set for installation of acoustic suppression kit.Do not allow components with rubber seals to slide on surfaces. Damageto rubber seals will result. Equipment damage could result if caution is notobserved.Use a minimum bridle of 5 feet on the hoisting sling to avoid undue sidepressure on the lifting frame. Equipment damage could result if caution isnot observed.NOTEIf generator set is trailer-mounted, generator set must be removed from trailer, and rub-ber issolaters supplied with kit placed between the generator set and trailer mountingsurface. When installing the generator set, attach anti-rotation dip, and attach themounting bolts. Blots should be torqued to 5 ft-lb (6.80 N•m) and jam nuts installed.(Jam nuts are common hardware items.) Once the acoustics suppression kit is installed,gen set will require 1 inch ground clearance. Do not skid gen set with acoustic suppres-sion kit installed. Do not forflift unless both side panel skirts are in the raised position.If generator set is trailer-mounted, the trailer brackets supplied with kit must beinstalled. The brackets allow for the extended length when the acoustic suppressionkit is installed.5-64
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
