ARMY TM 9-6115-464-12
AIR FORCE TO 35C2-3-445-1
NAVY NAVFAC P-8-624-12
4-34 START AID ASSEMBLY.
a.
Removal.
(1)
(2)
(3)
(4)
(5)
Remove tube assembly (1, Figure 4-22) and unscrew spray nozzle (2) from air cleaner housing.
Remove ether tank and install protective cap (4) on solenoid valve assembly (8).
Disconnect electrical connector (3) from solenoid valve assembly.
Remove nuts (5), screws (6), and lockwashers (7) to remove solenoid valve assembly (8).
Remove nuts (9), screws (10), and lockwashers (11 ) to remove clamp bracket (12) from day tank
assembly (13).
b. Cleaning and Inspection.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
Clean solenoid with filtered compressed air and a soft bristle brush or wipe with a clean lint-free cloth
lightly moistened with an approved solvent.
Clean all other parts with an approved solvent and dry thoroughly.
Visually inspect start aid solenoid valve for cracks, corrosion, stripped or damaged threads and evi-
dence of shorting or other damage.
Inspect ether tank bracket for cracks, breaks, corrosion, and other damage.
Inspect tube assembly for cracks, breaks, pinching, stripped or damaged threads, and other damage.
Inspect spray nozzle for cracks, corrosion, wear, clogging, or other damage.
Check all threads for stripping or other damage.
Replace any parts found defective.
c.
Installation.
(1) Install clamp bracket (12, Figure 4-22), lockwashers (11), screws (10), and nut (9) onto the day tank
assembly (13).
(2) Install solenoid valve assembly (8), lockwashers (7), screws (6) and nuts (5).
(3) Reconnect electrical connector (3) to solenoid valve assembly.
(4) Install ether tank and remove protective cap (4) from solenoid valve assembly (8).
(5) Screw spray nozzle (2) into air cleaner housing and install tube assembly (1).
4-57
