Figure 4-12. AC-DC Control Relay Assembly, Test Setup

Figure 4-11. Component Assembly Panel, Relay K1 and K50, Test Setup

TM-5-6115-593-34 Generator Set Diesel Engine Driven Tactical Skid Mtd. 600 Kw 3 Phase 4 Wire 120/208 and 240/416 Volts Manual
Page Navigation
59

TM5-6115-593-34 NAVFAC P-8-631-34 TO-35C2-3-463-2 Figure 4-12. AC-DC Control Relay Assembly, Test Setup TD1 R4 (1) 820 ohms, 25 watts, ±5 percent R1 (2) 2 k, 1 watt, ±5 percent R2 (3) 2.7 megohms, 25 watts, ±5 percent TD3 R1 (1) 2 k, 1 watt, ±5 percent R2 (3) 2 k, 1 watt, ±5 percent R4 (6) 20 k, 0.25 watts, ±5 percent R7 (8) 20 k, 0.25 watts, ±5 percent R6 (9) 200 ohms, 1 watt, ±5 percent R5 (12) 68 k, 0.25 watts, ±5 percent R3 (13) 6 k, 0.25 watts, ±5 percent (6) Check diodes CR1 (TD1), CR5, CR3 (TD3) as follows: (a) Disconnect one end of the diode. (b) Connect an ohmmeter (scale set Rx100) across the diode, note the reading. Now reverse ohmmeter leads to the diode, and again note reading. A good diode will read high 4-22

Privacy Statement
Press Release
Contact