TM 5-6115-593-34 NAVFAC P-8-631-34 TO-35C2-3-463-2 LEGEND FOR FIGURE  15-19 1. Screw 19. Nut 37. Screw 2. Deleted 20. Washer 38. Nut 3. Washer 21. Top side panel 39. Side panel 4. Nut 22. Screw 40. Screw 5. Clamp 23. Nut 41. Nut 6. Stripping 24. Washer 42. Side panel 7. Door LH 25. Screw 43. Screw 8. Door holder rod 26. Screw 44. Nut 9. Door and shutter assy 27. Nut 45. Side panel 10. Rivet 28. Washer 46. Screw 11. AC wiring diagram 29. Lower side panel 47. Nut 12. AC wiring diagram 30. Screw 48. Side panel 13. AC schematic plate 31. Nut 49. Screw 14. Screw 32. Washer 50. Washer 15. Nut 33. Screw 51. Post 16. Washer 34. Nut 52. Clamp 17. Bottom side panel 35. Washer 53. Clamp 18. Screw 36. Upper side panel screws (46) and nuts (47).  Install two screws (30), washers (32), and nuts (31) joining side panel (48) and upper side panel (36). (5) Similarly, install side panel (39) with five screws (40) and nuts (38) to support frame.  Add two screws (22), washers  (24),  and  nuts  (23)  to  attach  side  panel  (39)  to  lower  side  panel  (29).    Use  same  hardware  to attach two clamps (24A). NOTE Clamps (5, 52 and 53) are used to secure louver wiring harness (3, figure 15-23). (6) Install side panel (45) to support frame (at the top and bottom only) with five screws (43) and nuts (44). Install two screws (22), washers (24), and nuts (23) to join side panel (45) and lower side panel (29). (7) Install top side panel (21) to support frame with nine screws (18), washers (20), and nuts (19). (8) Install  bottom  side  panel  (17)  to  support  frame  with  nine  screws  (14),  washers  (16),  and  nuts  (15).    Use same hardware to attach three clamps (16A). (9) Install  pre-assembled  door  and  shutter  (9)  by  attaching  hinge  to  side  panel  (42)  with  twelve  screws  (1), washers (5), and nuts (4).  Use same hardware to attach two clamps (5).  Attach door holder rod (8); then close loop ends. (10) Similarly,  install  the  other  pre-assembled  door  and  shutter  assembly  (9)  to  side  panel  (39)  with  twelve screws (1), washers (3), and nuts (4).  Use same hardware to attach one clamp (5).  Attach door holder rod (8); then close loop ends. (11) Install access door (7) by attaching hinge to side panel (48) with twelve screws (1), washers (5) and nuts (4).  Attach door holder rod 98); then close loop ends. (12) Similarly,  install  the  other  access  door  (7)  by  attaching  hinge  to  side  panel  (45)  with  twelve  screws  (1), washers (3), and nuts (4).  Attach door holder rod (8); then close loop ends. (13) Install AC wiring diagrams (11 and 12) and AC schematic (13) 15-28