Rear.

TM-5-6115-593-34 Generator Set Diesel Engine Driven Tactical Skid Mtd. 600 Kw 3 Phase 4 Wire 120/208 and 240/416 Volts Manual
Page Navigation
318

TM 5-6115-593-34 NAVFAC P-8-631-34 TO-35C2-3-463-2 to access door (7) with eighteen rivets (10). (14) Attach corner post (51) to support frame with eight screws (49) and nuts (50); and install three screws (37) and nuts (38) attaching corner post (51) to support frame at the bottom. e. Rear. Refer to figure 15-20 and install as follows: (1) Attach corner post (36) to support frame with screws (34) and washers (35). (2) Similarly, attach corner post (39) to frame with screws (37) and washers (38). (3) Install upper panel (33) to both corner posts (36 and 39) with six screws (30), washers (32), and nuts (31). (4) Attach lower panel (24) to panel (20) with six screws (17) and washers (18). Attach bottom of panel (24) to top of panel (29) with seven screws (21), washers (22) and nuts (23). These three panels will be installed later on. (5) Install right-hand panel (12) to corner post (36) and upper panel (33) with ten screws (10). (6) Similarly, install left-hand panel (15) to corner post (39) and upper panel (33) with ten screws (13). (7) Install panels (20, (24), and (29) pre-assembled in step (4) by attaching to the base assembly with four screws (25), nuts (48), washers (26); and four screws (27), and washers (28). Bolt right-hand panel (12) to panel (20) with three screws (17), washers (18), and nuts (19). Bolt panel (24) to right-hand panel (15) with three screws (10). Bolt left-hand panel (15) bottom to panel (24) with three screws (10). Bolt ends of panel (24) to corner posts (36 and 39) with four screws (21), washers (22) and nuts (23). Install twelve screws around fuel tank filler neck area. Bolt panel (20) to left-hand panel (15) with three screws (17), washers (18), and nuts (19). (8) Install access door (9) to right-hand panel (12) with six screws (4) and nuts (5). Attach door holder rod (6); then close loop ends. (9) Install operating instructions plate (8) to access door (9) with six rivets (7). (10) Install access door (3) to left-hand panel (15) with six screws 91) and nuts (2). Attach door holder rod (6); then close loop ends . (11) Assemble cover and sleeve assembly by attaching sleeve (41) to cover slate panel (47) with bushing (40) and retainer plate (44) fastened with four screws (42) and nuts (43). Attach assembled panel to panel (20) with fourteen screws (45) and nuts (46). f. Top. Refer to figure 15-21, partially disassemble muffler assembly, and install housing kit top, as follows: (1) Refer to detail A of figure 15-21, remove eight screws and washers from the muffler support brackets as indicated. NOTE Retain screws and washers; they will be replaced later on. (2) Install panel (34) to support frame with fifteen screws (31) and washers (32). 15-29

Privacy Statement
Press Release
Contact