TM5-6115-593-34 NAVFAC P-8-631-34 TO-35C2-3-463-2 LEGEND FOR FIGURE 13-29 1. Hose assy 14. Lockwasher 28. Seat 2. Elbow 15. Body 29 Impeller 3. O-ring 16. Screw 30. Gasket 4. Water transfer 17. Lockwasher 31. Screw tube assy 18. Sheave 32. Lockwasher 5. Screw 19. Sheave 33. Connection 6. Lockwasher 20. Sheave 34. Gasket 7. Connection 21. Ring 35. Plug 8. Gasket 22. Bearing 36. Plug 9. Screw 23. Spacer 37. Bushing 10. Lockwasher 24. Ring 38. Plug 11. Plug 25. Shaft 39. Flange 12. Drain cock 26. Seal 40. Gasket 13. Screw 27. Impeller assy 41. Cover (c)   Press shielded bearing (22) with shielded side to retaining ring (24) over shaft until bearing seats against retaining  ring.    Bearings  go  on  "long" end of shaft using the retainer ring as a guide point. NOTE Apply load to inner bearing race only. (d)   Slide   bearing   spacer   (23)   over   shaft (25) against bearing. (e)   Place   bearing   (22)   with   open   side   to spacer,    over    water    pump    shaft    and press into place. (f)    Pack  space  between  bearings  55  to  65 percent (0.84 to 0.99 ounces - 24 to 28 g) full of grease MIL-G-3545. (g)   Press  shaft  and  bearing  assembly  into water pump body (15). (h)   Assemble  large  snap  ring  (21)  to  hold bearing and shaft in position. (i)    Place   rear   adjustable   sheave   (20)   on pulley  hub  (19);  press  pulley  hub  and sheave  onto  drive  shaft  until  hub  seats against bearing race.  Support other end of     shaft     during     pressing     operation; mount    front    adjustable    sheave    (18). Turn  water  pump  body  assembly  over and press in new carbon face seal (26) with  a  section  of  1-3/4  inch  (44.5  mm) inside   diameter   by   2   inch   (50.8   mm) outside diameter tubing until it seals. (j)    Lubricate the inside diameter of the new rubber   seat   (28)   with   a   light   coat   of permanent antifreeze. CAUTION Do  not  allow  any  lubricant  on  the  seal face. (k)   Slide   the   seal   seat   assembly   (rubber and  metal  seat  washer)  over  the  water pump  shaft  until  the  chrome  oxide  side of    the    washer    bottoms    against    the carbon face of the pump seal. (l)    Press impeller (29) onto shaft until there is 0.022 to 0.031 inch (0.56 to 0.79 mm) clearance between back of impeller and water pump body (15). (m) Install water pump 13-58