Figure 2-17. Stopping Instructions Using Remote Control Module

Figure 2-16. Starting Instructions Using Remote Control Module (Sheet 2 of 2)

Figure 2-18. Operating Instructions, Single Generator Unit Using Remote Control Module

TM-5-6115-593-12 Power Plant Utility (MUST) Gas Turbine Engine Driven (AMERTECH Corp Model APP-1) Manual
Page Navigation
67

TM 5-6115-593-12 TO 35C2-3-463-1 STEP 1. PLACE AC PWR CKT BKR SWITCH IN OPEN POSITION FOR APPROXIMATELY 2 OR 3 SECONDS, THE AC PWR CKT BKR CLOSED LIGHT SHOULD GO OUT. WARNING WILL SNAP SHUT RAPIDLY WITH CONSIDERABLE FORCE WHEN GENERATOR SET IS STOPPED. ENSURE ALL PERSONNEL ARE CLEAR OF SHUTTERS BEFORE PLACING MASTER SWITCH TO STOP. SERIOUS INJURY COULD RESULT. STEP 2. PLACE MASTER SWITCH IN STOP POSITION AFTER ALLOWING ENGINE TO COOL BY OPERATING AT NO LOAD FOR APPROXIMATELY 5 MINUTES. STEP 3. AFTER ENGINE HAS STOPPED, REMOVE DC POWER CONTROL BY SETTING 24V DC CONTROL CIRCUIT BREAKER (ON GENERATOR CONTROL PANEL) TO OFF POSITION. (ON GENERATOR CONTROL PANEL) TO OFF POSITION. Figure 2-17. Stopping Instructions Using Remote Control Module 2-36

Privacy Statement
Press Release
Contact