TM 5-6115-593-12
TO 35C2-3-463-1
WARNING
DO NOT OPERATE ENGINE GENERATOR SET UNLESS A GROUND CABLE HAS BEEN CONNECTED TO
THE GROUND TERMINAL STUD AND THEN TO A SUITABLE GROUND. ELECTRICAL FAULTS IN THE
GENERATOR SET, LOAD LINES, OR LOAD EQUIPMENT, CAN CAUSE INJURY OR ELECTROCUTION
FROM CONTACT WITH AN UNGROUNDED SYSTEM.
Figure 4-7. Grounding Procedures (Sheet 3 of 3)
STEP 1. INSERT GROUND CABLE INTO SLOT IN GROUND TERMINAL STUD AND TIGHTEN NUT.
STEP 2. PERFORM EXCAVATION AND BURY A METAL PLATE AS SHOWN.
STEP 3. ATTACH GROUND CABLE TO METAL PLATE AND CHECK THAT GOOD ELECTRICAL BOND IS
ACHIEVED. .
4-11
