Figure 7-30. Crankshaft Bearing Installation

Figure 7-28. Crankshaft Gear Removal - TM-5-6115-584-34_133

Figure 7-32. Injection Pump - TM-5-6115-584-34_135

TM-5-6115-584-34 Generator Set Diesel Engine Driven Tactical Skid Mtd. 30 Kw 3 Phase 4 Wire 120/208 and 240/416 Volts Manual
Page Navigation
102

TM 5-6115-584-34 NAVFAC P-8-622-34 TO-35C2-3-456-2 Figure 7-30. Crankshaft Bearing Installation to 0.015 inch end play. If more than 0.010 inch total thickness is required, then use a steel shim of proper thickness and an 0.005 inch thick gasket on each side of shim. This avoids excessive gasket compression and maintains bolt torque. Shims are available in 0.005, 0.010, 0.015, and 0.020 thick- ness. (7) Install keys (25) on crankshaft (26), then drive gear (16) into place using fabricated tool (see table 2-2). Install retaining washer (15) and lock ring (14). (8) Refer to paragraph 7-10 and install rod and piston assemblies. (9) Refer to paragraph 7-5 and install flywheel and housing. (10) Refer to paragraph 7-4 and 7-5 and install flywheel and housing. (11) Refer to paragraph 7-11 and install oil base. (12) Refer to paragraph 7-14 and install gear cover. (13) Refer to paragraph 7-8 and install alternator stator. Figure 7-31. Crankshaft End Play Measurement 7 - 2 9

Privacy Statement
Press Release
Contact