Figure 7-7. Battery Charge Alternator and Blower Wheel

Figure 7-8. Resistively Loading the Batteries - TM-5-6115-584-34_109

TM-5-6115-584-34 Generator Set Diesel Engine Driven Tactical Skid Mtd. 30 Kw 3 Phase 4 Wire 120/208 and 240/416 Volts Manual
Page Navigation
77

TM 5-6115-584-34 NAVFAC P-8-622-34 TO-35C2-3-456-2 TM-0568C-34 Figure 7-7. Battery Charge Alternator and Blower Wheel b. Removal. Remove screw (l), lockwasher (2) and c. Repair. Blower wheel and hub are a balanced washer (3), attaching blower wheel to crankshaft. Use two 5/16-24 screws in blower hub and a suitable puller to remove blower wheel (4) and key (5). NOTE Observe the arrangement of the conical washers in the torsion dampers before disas- sembly. These washers must be reassembled tn the same way or the function of the dampers will be impaired. unit and should not be disassembled. To replace tor- sion damper assemblies (6), remove screws (8), nuts (7) and replace torsional dampers. Torque screws 28-30 ft-lb. d. Install. (1) Mount blower wheel assembly to crankshaft using screw (l), lockwasher (2) and washer (3). Torque screw (1) to 65-70 ft-lb. (2) Refer to Operator and Organizational Maintenance Manual and install blower housing. 7-7

Privacy Statement
Press Release
Contact