TM  5-6115-584-12 NAVFAC  P-8-622-12 TO-35C2-3-456-1 TM-05682C-12 1. Screw (6) 22. shroud 2. Air duct cover 23. Nut 3. Screw (4) 24. Hook bolt 4. Shutter assembly 25.  Baffle 5.  Connector 26. Screw (3) 6. Clamp 27. Retainer (3) 7. Screw (4) 28.  Cover 8. Washer (4) 29.  Grille 9. Door panel and shroud assembly 30. Screw (5) 10. Rivet (3) 31. Screw (3) 11. Shroud 32. Blower housing 12. Door panel 33.  Screw 13. Screw (4) 34.  Screw 14. Latch (2) 35.  Clip 15. Screw (2) 36. Shroud 16.  Lockwasher  (2) 37. Lifting eye 17. Screw 38. High temperature cutout switch 18. Screw (4) 39. Lock tab 19. Tie bar (2) 40. Muffler 20. Screw (4) 41. Oil pressure gauge 21.  Tie  bar TS  6115-584-12/3-14(2) Figure 3-17. Engine Cooling Assembly (Sheet 2 of 2) 3-23. GENERATOR  ASSEMBLY. On   ASK   equipped   generators,   inspection   iS  limited   to screenguard   areas   visible   through   access   doors.   Inspect screenguard (3, figure 3-18) to see that is clean and free of Figure 3-18. Generator Assembly debris  and  free  of  dents  or  cracks.  Check  that  screen-guard is  securely  fastaned  in  place  over  opening  in  generator housing-stator assembly. Inspect end-bell (2) to see that it is clean and frae of cracks or other physical damage. Check that  openings  in  end-bell  and  end-bell  covar  are  free  of debris. Check that end-bell is securely attached to generator housing. 3-24. ENGINE ASSEMBLY. a.  Lifting  attachment  (see  figure  3-17).  On  ASK  equipped generators,  open  air  intake  door,  Inspect  for  cracks  or  other physical   damage.   Check   that   lifting   eye   (37)   is   securely mounted. b.  Intake  Manifold  Assembly  (see  figure  3-19).  On  ASK equipped  generators,  if  intake  manifold  is  suspected  of  possible problems, refer to higher level of maintenance. Inspect intake manifold (1) for cracks or physical damage. Check that manifold is properly secured to cylinder head and mounting screws (5) and lock tabs (3) are in place. c. Oil Drain Hose (see figure 3-20). On ASK equipped gener- ators, remove oil access door and inspect oil drain hose for physical  damage.  Check  that  drain  valve  operates  properly  and does not leak when closed. Check that oil drain hose is properly stored when not in use. d.  Engine  Mounting  Assemblies  (see  figure  3-19).  On  ASK equipped generators, remove oil access door and batteries access  door.  Inspect  engine  mounts  (13)  for  deterioration  or physical damage. Check for accumulations of dirt, fuel, or oil, Check  that  mounts  are  securely  attached  to  engine  and  to  skid- base  with  all  mounting  hardware  in  place. Change 7 3-23