TM 5-6115-584-12NAVFAC P-8-622-12TO 35C2–3-456–1TM-05682C-12(3)Install two screws (1) and washers (2) securingright panel assembly (3) to rear panel assembly (4).(4)Torque screws (1) to 18 ±2 in.-lbs dry.5-8.EXHAUSTPLENUMASSEMBLY.a.Removal.See figure 5-3.Remove exhaust plenumassembly from shutter assembly as follows:(1)Remove top panel assembly (3) as described inparagraph 5-4.(2)Remove four screws (13) and locknuts (14), andeight washers (15 and 16) securing exhaust plenum assembly (17)to shutter assembly (18) and lift off exhaust plenum assembly(17) .b.Installation.See figure 5-3.Install exhaust plenumassembly on shutter assembly as follows:(1)Position exhaust plenum assembly (17) on shutterassembly (18) and install four screws (13) and locknuts (14), andeight washers (15 and 16) securing exhaust plenum assembly (17)to shutter assembly (18).(2)Torque screws (13) to 16 ±2 ft-lbs dry.(3)Install top panel assembly (3) as described inparagraph 5-4.5-9.LEFTSUPPORTASSEMBLY.a.Removal.See figure 5-7.Remove left support assemblyfrom skid and left panel assembly as follows:(1)Remove four screws (1) and washers (2) securingaccess plate (3) to AC output control box (4).(2)Remove left panel assembly (5), as described inparagraph 5-5.(3)Loosen six screws (6) and slide out left supportassembly (7) from under skid (8).b.Installation.See figure 5-7.Install left supportassembly to skid and left panel assembly as follows:(1)With six screws (6) loosened, slide left supportassembly (7) between skid (8) and bevel washers (9).(2) Torque screws (6) to 26 ±2 ft-lbs dry.5-16Change 7
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
