TM 5-6115-584-12
NAVFAC P-8-622-12
TO 35C2-3-456-1
TM-05682C-12
(3) Install left panel assembly (5) as described in
paragraph 5-5.
(4)
Install access plate (3) to AC output control box
(4) with four screws (1) and washers (2).
5-10. RIGHT SUPPORT ASSEMBLY.
a.
Removal.
See Figure 5-8.
Remove right support
assembly from skid and right panel assembly as follows:
(1) Remove right panel assembly (1) as described in
paragraph 5-6.
(2) Loosen six screws (2) securing right support
assembly (3) to skid (4) and slide out right support assembly (3)
from under skid (4).
b.
Installation.
See figure 5-8.
Install right support
assembly to skid and right panel assembly as follows:
(1) With six screws (2) loosened, slide right support
assembly (3) between skid (4) and bevel washers (5).
(2) Torque screws (2) to 26 ±2 ft-lbs dry.
(3) Replace right side panel (1) as described in
paragraph 5-6.
5-11. FRONT PANEL ASSEMBLY.
a.
Removal.
See figure 5-9.
Remove front panel assembly
from top, right and left panel assemblies as follows:
(1) Remove four screws (1) and washers (2) securing
the front panel assembly (3) to top panel assembly (4).
(2)
Remove six screws (5) and washers (6) securing
front panel assembly (3) to left panel assembly (7) and right
panel assembly (8).
(3) Remove front panel assembly (3).
b.
Installation.
See figure 5-9.
Install front panel
assembly to top, right and left panel assemblies as follows:
(1) Position front panel assembly (3) against left
panel assembly (7) and right panel assembly (8) and secure with
six screws (5) and washers (6).
(2)
Install four screws (1) and washers (2) securing
front panel assembly (3) to top panel assembly (4).
(3) Torque screws (5 and 1) to 18 ±2 in.-lbs dry.
5-18
Change 7
