TM 5-6115-584-12
NAVFAC P-8-622-12
TO 35C2-3-456-1
TM-05682C-12
b.
Installation.
See figure 5-2.
Replace cover assembly
consisting of top panel assembly, left and right panel assemblies
and front panel assembly on generator as follows:
WARNING
The ASK Cover assembly is heavy.
Four (4) people are
required to lift cover.
Failure to follow safety
rules could result in personal injury.
(1)
Position cover assembly on generator set.
(2)
Install seven screws (22) and locknuts (23), and
14 washers (24 and 25) securing top panel assembly (26) to rear
closure assembly (21) and side closure assembly (9).
(3)
Torque screws (22) to 16 ±2 ft-lbs dry.
(4)
Install two screws (17) and locknuts (18), and
four washers (19 and 20) securing right panel assembly (12) to
rear closure assembly (21) and install two screws (14) and
washers (15) securing right panel assembly (12) to rear panel
assembly (16).
(5)
Torque screws (17) to 16 ±2 ft-lbs dry.
(6)
Torque screws (14) to 18 ±2 in.-lbs dry.
(7)
Install five screws (10) and washers (11) securing
right panel assembly (12) to right support assembly (13).
(8)
Torque screws (10) to 18 ±2 in.-lbs dry.
(9)
Install three screws (5) and locknuts (6), and six
washers (7 and 8) securing left panel assembly (3) to side
closure assembly (9)
(10) Torque screws (5) to 16 ±2 ft-lbs dry.
(11) Install three screws (1) and washers (2) securing
left panel assembly (3) to left support assembly (4).
(12) Torque screws (1) to 18 ±2 in.-lbs dry.
5-4.
TOP PANEL ASSEMBLY.
a
.
Removal.
See figure 5-3.
Remove top panel assembly
from left, right and front panel assemblies and side and rear
closure assemblies as follows:
(1) Remove 11 screws (1) and washers (2) securing top
panel assembly (3) to left panel assembly (4), right panel
assembly (5) and front panel assembly (6).
5-8
Change 7
