Figure 3-53.
TM 5-6115-545-12
TO 35C2-3-444-1
NAVFAC P-8-626-12
TM 00038G-12
Section XLV. ACCESSORY ITEMS
3-226. General.
~. The engine generator set is provided with a paralleling
cable assembly (class 1 only) and an auxiliary fuel line. (Refer
to fig. 3-53.)
~. The paralleling cable assembly is a 25 foot, four
conductor, flexible, heat and oil resistant cable, which is utilized
with the paralleling receptacle to interconnect two precise
generator sets.
Q. The auxiliary fuel line hose assembly is a 25 foo~
flexible, heat and oil resistant hose which is utilized to
intercmmect the engine generator set to supply or receive fuel.
3-227. Paralleling Cable Assembly
Q. -. Test each parallel wire for continuity, ensuring
wire is not shorted to connectors or adjacent wires. Wire
routing is common between like pins of connectors: A to A, B
to B, etc.
b. ~.
No special instructions
are required to install or replace a paralleling cable
(1, fig. 3-53). When not installed, coil paralleling cable into a
loop and install with chain provided in housing on right side of
relay table. (See fig. 1-1.).
3-228. Auxiliary Fuel Line Hose Assembly.
a. Installation and Replacement. No special instructions
we required to install or replace the auxiliary fuel line hose (2,
fig. 3-53). When not installed coil auxiliary fuel line hcse into
a loop, with ends connected and install on chain provided in
housing beneath the governor control unit. (See figure l-l.)
b. &p&. Replace defective hose (6, fig. 3-53) fittings.
3-229. Storage Space.
Storage space for ground rods is provided on left side of skid
base charmel facing battery tray. Connectors and ground wire
should be stowed in tool box (fig. 1-1) under governor actuator
assembly.
3-118
Change 18
