TM 5-6115-465-34
TO35C2-3-446-2
NAVFACP-8-625-34
TM06858B/06859D-34
Tactical Relay Resistor Assembly Schematic Diagram
Figure 5-17.
a . Removal.
(b) Touch other lead to terminals 3, 2,
and 1.
(1) Tag and disconnect electrical connectors
to special relay assembly.
(c) Ohmmeter should indicate 7.5 ohms
in each case.
(2) Remove screws (1, figure 5-19) and lock-
washers (2) to remove special relay assembly.
(15) Replace defective components of tactical
relay resistor assembly using figure 5-18 as a guide.
b. Disassembly. Disassemble special relay as-
sembly (items 3 through 49, figure 5-19) only as re-
(16) If the wiring harness has sustained dam-
quired for inspection, testing, and replacement of
age and requires repair or rebuild, refer to figure
components.
ments and Appendix A for detailed soldering and re-
c.
Cleaning, Inspection, and Repair.
placement procedures.
(1) Clean special relay components with filter-
d. Installation. Install tactical relay assembly
ed compressed air and a soft bristle brush. If neces-
in reverse order of removal procedures.
sary, dirt deposits may be removed with a clean, lint-
free cloth moistened in an approved solvent.
5-11.
SPECIAL RELAY ASSEMBLY<
(2) inspect potentiometer for cracked casing,
corroded terminals and burns or other indication or
shorting.
Do not attempt to perform maintenance on
the special relay assembly while the gen-
(3) Inspect wiring harness assembly for
cracked or deteriorated insulation, damaged or loose
erator set is operating. Severe electrical
shock or death may result from failure to
connector pins, and burned areas indicating shorting.
observe this warning.
5-25
