TM 5-6115-465-34
TO 35C2-3-446-2
NAVFAC P-8-625-34
TM06858B/06859D-34
42. Commutator end frame
1,
Nut
43. Packing
2.
Lockwasher
44. Spacer washer
9.
Terminal lead
45. Plug
4.
Screw
46. Oil wick
5.
Solenoid assembly
47. Bushing
6.
Nut
48. Pin
7.
Flat washer
49. Brush spring
8.
Insulating washer
50. Brushholder
9.
Nut
51. Screw
10.
Lockwaeher
52. Electrical lead
11.
Nut
53. Brush
12.
Flat washer
54. Armature
13.
Insulating washer
55. Housing
14.
Screw
56. Nut
15.
Flat washer
57. Flat washer
16.
Cover
58. Insulating washer
17.
Gasket
59. Screw
18.
Frame assembly
60. Pole shoe
19.
Nuts
61. Field coil assembly
20.
Lochwasher
62. Insulator
21.
Nut
63. O-ring
22.
Flat washer
64. Packing
23.
Insulating washer
65. Screw
24.
Terminal stud
66. Lockwasher
25.
Terminal stud
67. Drive housing
26.
Contact strip
68. Gasket
27.
Spring
69. Plug
28.
Contact assembly
70. Oil wick
29,
Plug
71. Bushing
30.
Retaining ring
72. Plug
31.
Pin
73. Pivot pin
32.
Boot clamp
74. Retaining ring
33.
Plunger
75. Retainer
34.
Retaining ring
76. Clutch assembly
95.
Spring retainer
77. Shift lever
36.
Spring
78. Bushing
37.
Boot
79. Bushing
38.
Spring retainer
80. Guide pin
39.
Washer
81. Shifter housing
40.
Retaining ring
82. Bushing
41.
Bolt
83. O-ring
ME 5-6115-465-34/3-1 (2)
Starter Assembly, Exploded View (Sheet 2 of 2)
Figure 3-1.
CAUTION
(23) Remove retaining ring (74) and retainer
(75).
Do not use dry cleaning solvent to clean
electrical parts.
(24) Rotate clutch assembly (76) counterclock-
wise to remove from shaft of armature (54),
(1) Clean all metal non-electrical parts in an
(25) Remove shift lever (77), but do not re-
approved solvent and dry thoroughly with filtered
move bushings (78 and 79) or guide pin (80) from
compressed air.
shifter housing (81) unless inspection reveals defects.
CAUTION
(26) Remove bushing (82) and o-ring (83).
When cleaning field coils, use extreme
care to avoid damaging protective in-
c.
Cleaning, Inspection, and Repair.
sulation.
3-3
