P-9-TM-457-35 T. 0. 35C2-3-442-2
TM-07464A-35 TM 5-6115-457-34
Legend to figure 8-19:
16.
1,
Lock washer (2)
Bolt (2)
2.
Tube
Lock washer (2)
17.
Tube assembly
Fitting
18.
3.
19.
Gasket
4.
Fitting
5,
20.
Seal
Bolt
6,
Bolt
21
Lock washer
7.
Lock washer
22.
Bolt
8.
23.
Bolt
Lock washer
9.
24.
Bolt
lock washer
10.
Lug
25.
Lock washer
11.
Clip
Bolt
26.
Tube assembly
12.
27.
Lock washer
13.
Gasket
28.
Oil cooler group
Seal
14.
29.
Gasket
15.
Bolt (2)
30.
Gasket
b. Repair minor thread damage using
8-81. INSPECTION.
a suitable thread chaser.
a. Inspect tube bundle and end bonnets
8-83. REASSEMBLY.
for cracks, breaks, corrosion that cannot
be removed, and any other defects. Replace
Refer to figure 8-20 and reassemble
defective components.
oil cooler group in the reverse order of
index numbers assigned.
b. Inspect components for dents, cracks,
distortion, and damaged threads.
8-84. INSTALLATION.
c. Discard gaskets and seals,
a. Refer to figure 8-19, and install oil
d. Using a suitable spring compressor,
cooler group in the reverse order of index
numbers assigned.
apply a load of 8.92 Ibs. and compress
relief valve spring (10, figure 8-20) to a
length of 2.5 inches. Replace relief valve
b. Install gasket and oil filler tube to
spring (10) if free length after test is not
cylinder block and secure with three wash-
3.61 inches.
ers, lock washers and bolts.
8 - 8 2 . REPAIR.
c. Refer to Operator and Organizational
a. Repair dents and distortion using
Maintenance Manual and install oil filter
proper tools.
group.
8-43
