P-9-TM-457-35
T.O. 35 C2-3-442-2
TM 5-6115-457-34
TM-07464A-35
Table 1-1. Repair and Replacement Standards (continued)
MAXIMUM
MANUFACTURER'S
ALLOWABLE
DIMENSIONS AND
WEAR AND
TOLERANCES
DESIRED CLEARANCE
CLEARANCE
IN INCHES
COMPONENT
MAX
MIN
MAX
MIN
Utility Governor Group:
(continued)
0.0005
Gearlands (3) O.D.
0.5685
0.5675
0.0005
0.376
0.377
Bushing (2) I.D.
0.001
0.3735
Speed adjusting shaft O. D. 0.373
0.001
0.373
0.374
Terminal shaft O.D.
0.0005
0. 187
0.188
Relief valve sleeve I.D.
0.0005
0.4373
0.4370
Relief valve sleeve O.D.
0.0005
0.3130
0.3133
Idler gear stud O.D.
1.120
1.216
0.0005
Idler gear O.D.
Idler gear 1. D.
(measured over 0.148
0.3140
0.3150
diameter pins)
0.001
1.126
1.120
Drive gear O. D.
0.0005
0.184
0.182
Relief valve plunger O. D.
Fuel Injection Group:
0.5007
0.5013
Rack bearing bore
0.4987
0.4983
Fuel rack diameter
Fuel rack bearing
0.005
clearance
2.5881
2.5931
2.5937
Pump plunger length
1.876
1.875
Cam shaft bearing bore
Camshaft bearing
1.8725
1.8735
journal diameter
Camshaft bearing
0.010
clearance
Accessory Drive Group:
0.018
0.016
0.004
Idler gear end clearance
1.376
1.381
Idler gear bearing bore
0.009
1.3746
1.3736
Idler gear shaft diameter
1-34
