TM 5-6115-400-12
Figure 2-1. Lifting and towing slings.
AWG (American Wire Gage) copper wire and be bolted
f. Load Connections. Refer to figure 2-3 and
or clamped to the rod, plate, or piping system. Connect
connect the load cable to the generator set.
the other end of the ground lead to the generator set
ground terminal stud (fig. 1-2).
Note. The load terminals will accommodate 2-wire,
single phase, and 4-wire, 3-phase loads. One or more
Warning
single-phase loads can be served alone in combination
Do not operate the generator set unless the
with 3-phase loads, but the load on any one phase must
ground terminal stud has been connected to a
not exceed 25% of the current rating of the generator
suitable ground.
Electrical faults in the
set.
generator set, load lines, or load equipment,
can cause injury or electrocution from contact
g. Auxiliary Fuel Lines. If an auxiliary fuel source
with an ungrounded system.
is to be used, be sure the auxiliary fuel 2-3
2-3
