• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Figure 5-13. Relay Board Harness Assembly W11 Removal.
Table 5-3. Output Connector Harness Continuity Check

TM-9-6115-660-13P Power Plant Diesel Engine Driven 1-Ton Trailer Mounted (With Racks) 3Kw 60 Hz AN/MJQ-42 Manual
Page Navigation
  142    143    144    145    146  147  148    149    150    151    152  
TM 9-6115-660-13&P REMOVAL 1. Remove four screws (1), lock washers (2), flat washers (3), and invert relay board assembly (4). NOTE Other leads removed during removal of W11 harness leads must be replaced with any attaching hardware. 2. Refer to relay board harness wire list (table 5-2), and tag and disconnect all W11 leads from terminal board (5) and relay sockets (6). 3.  Remove  relay  board  harness  W11. REPAIR Refer to figure G-2, appendix G. INSTALLATION 1. 2. 3. . Position wiring harness W11 on relay board so that wire ends having terminal lugs are near TB1 terminals (5). Refer to table 5-2 and connect all W11 leads. Position relay board assembly (4), and install four flat washers (3), lock washers (2), and screws (1). 5-10 OUTPUT CONNECTOR HARNESS W10 MAINTENANCE. This  task  covers:  a. Test c.  Repair b. Removal d. Installation INITIAL  SETUP Tools Equipment  Conditions Tool  Kit,  General  Mechanic’s Reference (item 1, appendix B) Solder Gun (item 3, appendix B) Both  generator  sets  shut  down;  paragraph Crimping Tool, Hydraulic (item 4, appendix B) 2-5.3.3.  Trailer  handbrakes  set,  front  support Multimeter  (item Materials/Parts Solder Lock  washers 3, appendix B) leg/landing  lowered,  and  rear  leveling-support jack  lowered;  paragraph  2-3.2.1.  Switch  box cover  open. 5-23







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.