• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
5-10 OUTPUT CONNECTOR HARNESS W10 MAINTENANCE.
Figure  5-14.  Output  Connector  Harness.

TM-9-6115-660-13P Power Plant Diesel Engine Driven 1-Ton Trailer Mounted (With Racks) 3Kw 60 Hz AN/MJQ-42 Manual
Page Navigation
  143    144    145    146    147  148  149    150    151    152    153  
TM  9-6115-660-13&P TEST 1. Check continuity of output connector harness as listed in table 5-3. Table 5-3. Output Connector Harness Continuity Check . FROM TO CONTINUITY NO  CONTINUITY L0 L1 x L0 L2 x L0 L3 x L0 GND x L1 L2 x L1 L3 x L1 GND x L2 L3 x L2 GND x L3 GND x J1-A L1 x J1-B L2 x J1-C L3 x J1-N x J1-G GND x 2.  If  any  wire  fails  continuity  check,  repair  or  replace  output  connector  harness. REMOVAL 1. 2. 3. Remove nuts (8, figure 5-14), and internal tooth washers (9), from switch  box load terminals (11). NOTE Other leads removed during removal of W11 harness leads must be replaced with any attaching hardware. Tag and remove output connector leads (10) from switch box load terminals (11). Remove four nuts (7) lock washers (6), eight flat washers (2), chain (3) attached to dust cover, four screws (1), and output connector (4). 5-24







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.