TM 9-6115-668-13
Provide support for the starter.
1.
Install starter (10) on flange of diesel engine (2) using three serrated lock washers (13), three wash-
ers (14), and three nuts (12). lighten nuts (12).
2.
Install screw (9), serrated lock washer (8), washer (7), clamp (6), positive cable (3), molded part (5),
and sealing ring (4) on starter (10). Tighten screw (9).
3.
Install cable (11), washer (27), serrated lock washer (28), on stud (26) on starter terminal board
(15), and install nut (29). Tighten nut (29).
4.
Install cables (22, 21), washer (23), serrated lock washer (24), on stud (20) on starter terminal
board (15), and install nut (25). Tighten nut (25).
5.
Install cable (3), washer (17), serrated lock washer (18), on stud (16) on starter terminal board (15),
and install nut (19). Tighten nut (19).
6.
Connect the negative battery cable first and then the positive battery cable.
7.
Install unit hood assembly (1) as instructed in paragraph 4.14.
4-223
