TM 9-6115-668-13
1. Install Resistor R100 (55)
Before Installing each resistor, apply thermoconductlve paste to the
back.
Installation procedure for resistors R101 and R102 Is the same as for
resistor R100, described below.
a. Install resistor R100 (55) on mounting plate (58) using two screws (49), two serrated lock wash-
ers (50), and two washers (51).
b. Solder cable (52) to resistor R100 (55).
2.
Install speed governor assembly N1 (43) as instructed in paragraph 5.13.
3.
Stow prop (5) and close front panel (4).
4. Close flap (2).
4 - 1 5 9
