TM 9-6115-668-13NOTEThe Generator Set 150 kW is packaged with a residual amount of fueland with battery terminals detached.4.4.2 Unpacking Equipment.4.4.2.1 Unpacking Generator Set 150 kW using a Forklift.a.b.C.d.e.f.Remove cover (1, figure 4-2) and square wooden members (2).Remove one side (wide side).Detach film at points (3). The forklift sockets (1, figure 4-3) are located here.NOTEThe unit is secured to the bottom of the container with squarewooden members only (no threaded fasteners), and can be liftedup.Separate the unit from the container using a forklift.Insert forks, lift unit with packaging, and lower onto a solid surface.Remove all film material from the unit.Prepare the Generator Set 150 kW for start-up as instructed in chapter 2.4.4.2.2 Unpacking Generator Set 150 kW using a Crane.a.Remove cover and four sides of the container (figure 4-1).b.Detach film so the four eyebolts (2, figure 4-3) at the corners are accessible.c.Suspend the sling assembly from the crane and position the crane approximately above the centerof Generator Set 150 kW as shown in figure 4-3.d.Insert the four cable hooks of the sling assembly into the lifting rings (2). Lift up the Generator Set150 kW with the crane and lower it onto a solid surface.WARNINGDo not stand in the operating area of the crane. Do not walk underthe suspended load.Move the Generator Set 150 kW slowly so that it remains In the hori-zontal position.e.Detach the sling assembly from the Generator Set 150 kW.4 - 7
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
