Figure 2-16 Engine Preheating Plate.

Figure 2-17 Generator Set 150 kW Short Operating Instructions Plate (sheet 1 of 2).

TM-9-6115-668-13 5Kw 28VDC Auxiliary Power Unit (APU) MEP 952B Manual
Page Navigation
73

TM 9-6115-668-13 SHORT OPERATING INSTRUCTIONS EG 150KW / EPP 2 x 150KW / 400HZ, 120/208V NSN: Ambient temperature <-30°C. 1. 2. 3. 4. Connect external battery to external starting plug socket. Switch on the cold-start heater - push the HEATING ON button. If HEATING FAILURE lamp lights up, first push HEATING OFF button, then turn on cold-start heater again. Wait for READY TO START lamp to light up (approx. 25 minutes), then start the engine. For extended engine service life, always use the cold-start heater whenever ambient temperature is less than -10 °C. WARNING: Always wear gloves! During engine start, a second person must pull the actuator lever as far as it will go. NOTE NOTE LECHMOTOREN Lechmotoren GmbH Südl. Römerstr. 12-16 * D-86972 Altenstadt/Schongau, Germany Telephone: +49 (8861) 710-0 * Telex: 59717 Telefax: +49 (8861) 710-180/-181 Figure 2-16 Engine Preheating Plate. 2-50

Privacy Statement
Press Release
Contact