TM 9-6115-662-13&P NOTES: 1. 2. 3. 4. 5. 6. 7. HOT STAMP “W7” AND “97403-13229E5800-” WITH APPROPRIATE DASH NO. ON SLEEVING,  FIND NO. 6 IN ACCORDANCE WITH MIL-M-60903. LOCATE APPROXIMATELY AS SHOWN. HOT STAMP SLEEVING,  FIND NO. 10, WITH WIRE ADDRESS WITHIN 2 INCHES OF ITS TERMINATION, IN ACCORDANCE WITH MIL-M-60903. THE ADDRESS CONSISTS OF THE FROM TERMINATION, A DOUBLE HEADED ARROW AND THE TO TERMINATION. SOLDER CONNECTIONS SHALL BE IN ACCORDANCE WITH MIL-STD-2000, USING SOLDER, FIND NO. 8. STRIP AND TIN ENDS IN ACCORDANCE WITH MIL-STD-2000. CRIMPED  CONNECTIONS  SHALL  BE  IN  ACCORDANCE  WITH  MIL-E-45782. BUNDLE WIRES USING TIE DOWN STRAPS, FIND NO. 9, AT INTERVALS OF 3.00 MAX. AND AT ALL BREAKOUTS. WIRE NO. 2 AND 12 SHALL TERMINATE AT TERMINAL, FIND NO. 3 OR 4. CRIMP WIRES IN TERMINAL, FIND NO. 3 OR 4, AND SOLDER. WIRE  LIST TERMINATION TERMINATION WIRE FIND NO. WIRE NO. FROM FIND  NO. TO FIND NO. 1 J4-A 1 K1-A1 7 2 2 J4-B 1 L0 3 OR 4 2 3 J4-C 1 K1-Y 5 2 4 J4-D 1 K1-X 5 2 5 J4-F 1 K1-11 5 2 6 J4-G 1 K1-12 5 2 7 J4-H 1 K2-12 5 2 8 J4-I 1 K2-11 5 2 9 J4-K 1 K2-X 5 2 10 J4-L 1 K2-Y 5 2 11 J4-M 1 K2-A1 7 2 12 J4-N 1 L0 3 OR 4 Figure G-2. Control Wiring Harness W7 (Sheet 2). G-5