TM 9-6115-662-13&PSection III. MAINTENANCE PROCEDURES5-5 GENERAL.Refer to TM 9-6115-644-24 for generator set maintenance, and to TM 9-2815-255-24 for enginemaintenance. Refer to TM 9-2330-205-14&P for trailer maintenance. Direct Support level maintenanceprocedures are provided in paragraphs 5-6 through 5-14.5-6 REPLACE GENERATOR SET.This task covers: a. Removalb. InstallationINITIAL SETUPToolsEquipmentConditionsTool Kit, General Mechanic’sReference(item 1, appendix B)Lifting device with 6000 lb capacityBoth generator sets shut down, para 2-5.3.1.Materials/PartsPersonnelRequiredNuts, Self-locking4RopeREMOVAL1.2.3.4.5.When removing the generator set from unit A of the power plant, disconnect P1 (3, Figure 5-10)from generator set.Loosen GND terminal of generator set and disconnect ground cable (5) from the generator set.Remove the four screws (1), eight flat washers (7), and four self-locking nuts (6) securing the generatorset to the trailer.Insert ropes (10) through each of four Ming rings (8) on the generator set as shown in figure 5-10.With one person at each rope (10) to steady and guide generator set (9), life generator set.INSTALLATIONWARNINGWhen lifting the generator set, use lifting equipment with a minimum lifting capacity of6000 lb. Do not stand under the generator set while it is being lifted. Do not permitgenerator set to swing. Failure to observe this warning can result in severe personalinjury or death.5-13
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
