Figure 5-22. Replace AN/MiQ-37 and AN/IMJQ-38 Generator Mounting Rails.

5-17 AN/MJQ-37, AN/MJQ-38, PU-798, AND PU-799 TRAILER FENDER REPAIR.

5-19 PU-798 AND PU-799 GENERATOR MOUNTING RAIL MAINTENANCE

TM-9-6115-660-13P Power Plant Diesel Engine Driven 1-Ton Trailer Mounted (With Racks) 3Kw 60 Hz AN/MJQ-42 Manual
Page Navigation
165

TM 9-6115-660-13&P REMOVAL NOTE Rails may be shimmed; note location and quantity. Mounting hardware quantity may vary depending on mounting rail being removed. Longer bolts are used at front end of mounting rails. Remove self-locking nuts (1, figure 5-22), flat washers (2), cap screws (3), and mounting rail (4). REPAIR NOTE Blind nuts are located at front end of both mounting rails. Repair of mounting rails consists of replacing blind nuts (5). Refer to instructions supplied with blind nut tool. INSTALLATION Position mounting rail (4) on trailer and loosely install cap screws (3), flat washers (2), self-locking nuts (1), then tighten. Figure 5-22. Replace AN/MiQ-37 and AN/IMJQ-38 Generator Mounting Rails. Change 2 5-41

Privacy Statement
Press Release
Contact