TM 9-6115-604-34
NAVFAC P-8-633-34
CHAPTER 2
GENERAL MAINTENANCE INSTRUCTIONS
SECTION I. REPAIR PARTS, SPECIAL TOOLS, TEST MEASUREMENT AND DIAGNOSTIC EQUIPMENT (TMDE),
AND SUPPORT EQUIPMENT
2-1. REPAIR PARTS. Repair parts and equipment are tested and illustrated in TM 9-6115-604-24P, the Repair Parts
and Special Tools List for the generator set.
2-2. SPECIAL TOOLS, TEST AND SUPPORT EQUIPMENT. Special tools, test, and support equipment are listed in
Table 2-1.
2-3. FABRICATED TOOLS AND EQUIPMENT. Refer to Table 2-2.
Table 2-1. Special Tools, Test, and Support Equipment
Reference
Item
NSN or
Fig. No.
Para No.
Use
Fig.
Reference No.
Stopwatch
403.201
5-34
Testing over/under voltage
--
5-35
relays K110/ K111 and
5-36
overcurrent relay K114.
Counterboring
ST-1010
--
9-11
Sleeving water holes.
--
Tool, Water Hole
(15434)
Tester, Hydrostatic
ST-1012
Figure 9-5
9-8
Testing cylinder heads. Requires
--
(15434)
3375070 adapter plates and
3375071 packings.
Driver, Rear Seal/
ST-1093
--
9-33
Installing rear wear ring and
--
Wear
(15434)
crankshaft seal. Also to align
seal retainer.
Manometer
ST-1111-3
Figure 12-1
12-3
For use with 3375767
--
(15434)
manometer.
Puller, Main
ST-1116
--
9-22
Removing main bearing caps.
--
Bearing Cap
(15434)
Driver, Valve Seat
ST-1122
--
9-11
Installation of valve seat inserts.
--
Insert Staking
(15434)
Guide, Head,
ST-1134
--
9-11
Removing dowel pins and cross-
--
Dowel Pin
(15434)
head guides.
Magnetic Crack
ST-1166
--
9-8
Testing for surface cracks in
--
Detector
(15434)
cylinder head.
Counterbore Tool,
ST-1168
--
9-31
Repairing liner counterbore in
--
Liner
(15434)
cylinder block.
Bore Tool, Main
ST-1177
--
9-31
Boring main bearing bores.
--
Bearing
(15434)
Crankshaft
ST-1196
--
9-28
Testing crankshaft hardness.
--
Hardness Tester
(15434)
Plate, Puller
ST-1209
--
9-24
For use with 3375629 cylinder
--
(15434)
liner puller.
Driver Set,
ST-1228
Figure 9-18
9-16
Removing and installing
--
Camshaft
(15434)
camshaft bushings.
Bushing
2-1