Figure 9-76. Balance of Impeller and Turbine Wheel Shaft Assembly

Figure 9-75. Balance of Turbine Wheel and Shaft

TM-9-6115-604-34 Generator Set Diesel Engine Driven Tactical Skid Mtd 5 Kw. 1 Phase-2 Wire 1 Phase -3 Wire 3 Phase -4 Wire 120. 120/240 and 120/208 Volts Manual
Page Navigation
426

TM 9-6115-604-34 NAVFAC P-8-633-34 Figure 9-76. Balance of Impeller and Turbine Wheel Shaft Assembly f. Assemble. CAUTION All parts and the work area must be free of grease and oil to avoid attracting dirt and abrasive. Even small amounts of dirt or abrasive material will cause premature wear of the turbocharger. Do not lubricate the bearings and thrust washers until they are ready to be Installed. NOTE Just prior to installation, coat the washers (23), bearings (22), thrust bearing (20), thrust collar (19), seal rings (11 and 14), and the thrust spacer (13) with lubricating oil, MIL-L-2104. (1) Install a new retaining ring (24) at each end of the center housing (18). (2) At the turbine end of the center housing (18), install a washer (23) against the retaining ring (24), install the bearing (22), and secure with a new retaining ring (24). 9-130

Privacy Statement
Press Release
Contact