Figure 9-74. Inspection of Turbine Wheel and Shaft

Figure 9-72. Inspection of Turbine Housing

TM-9-6115-604-34 Generator Set Diesel Engine Driven Tactical Skid Mtd 5 Kw. 1 Phase-2 Wire 1 Phase -3 Wire 3 Phase -4 Wire 120. 120/240 and 120/208 Volts Manual
Page Navigation
423

TM 9-6115-604-34 NAVFAC P-8-633-34 Figure 9-74. Inspection of Turbine Wheel and Shaft (15) Check the thrust bearing (20) for scoring or grooving, and check the thickness using an outside micrometer. Scoring shall not exceed 0.003 inch (0.08 mm) in depth, and the minimum thickness shall be 0.090 inch (2.29 mm). (16) Check the bearings (22) for scoring and wear on the inside and outside diameters. Scoring shall not exceed 0.003 inch (0.08 mm) in depth. The maximum inside diameter shall be 0.6272 inch (15.931 mm). The minimum outside diameter shall be 0.9782 inch (24.846 mm). (17) Check the washers (23) for scoring or grooving. Scoring shall not exceed 0.003 inch (0.08 mm) in depth. d. Repair. (1) Replace all defective parts in accordance with the directions in step c, above. Figure 9-73. 9-127

Privacy Statement
Press Release
Contact