Figure 9-16. Installation of Timing Gears

TM-9-6115-604-34 Generator Set Diesel Engine Driven Tactical Skid Mtd 5 Kw. 1 Phase-2 Wire 1 Phase -3 Wire 3 Phase -4 Wire 120. 120/240 and 120/208 Volts Manual
Page Navigation
330

TM 9-6115-604-34 NAVFAC P-8-633-34 REF PART NAME BACKLASH* END CLEARANCE* NO. INCHES (mm) 1 CRANKSHAFT 0.005 TO 0.015 (0.13 TO 0.38) 2 LB CAM IDLER GEAR 0.0003 TO 0.012 0.005 TO 0.011 (0.076 TO 0.30) (0.13 TO 0.28) 3 WATER PUMP IDLER 0.0003 TO 0.012 0.005 TO 0.011 GEAR (0.076 TO 0.30) (0.13 TO 0.28) 4 LB CAMSHAFT GEAR 0.003 TO 0.012 0.006 TO 0.013 (0.076 TO 0.30) (0.15 TO 0.33) 5 RB CAMSHAFT GEAR 0.003 TO 0.012 0.006 TO 0.013 (0.076 TO 0.30) (0.15 TO 0.33) 6 RB CAM IDLER GEAR 0.003 TO 0.012 0.005 TO 0.011 (0.076 TO 0.30) (0.13 TO 0.28) *DIMENSIONS ARE MANUFACTURING TOLERANCES, REFER TO TEXT FOR WORN LIMITS. Figure 9-16. Installation of Timing Gears (21) Install the front engine support in accordance with paragraph 9-36. (22) Install the radiator in accordance with the Operator and Organizational Maintenance Manual. CAUTION Serious engine damage will result If the engine Is started before the lubrication system Is properly filled and primed. Elapsed time between priming the lubrication system and starting the engine shall not exceed 3 hours If, for whatever reason, the engine cannot be started within 3 hours after priming the lubrication system, repeat the entire priming procedure just prior to starting the engine. (23) Before starting the engine, fill and prime the lubrication system in accordance with the Operator and Organizational Maintenance Manual. 9-34

Privacy Statement
Press Release
Contact