TM 9-6115-604-34NAVFAC P-8-633-34f.Install the body (29) on the cover (11) with the gasket (28) and machine screws (30).NOTETurn the end of the drive shaft (26) from inside the cover (12) toensure that the drive shaft (26) and gear (25), and the idle shaft (24)and gear (23), rotate freely inside the pump assembly (8) after themachine screws (30) have been tightened.g.Install the by-pass valve assembly (15) in the cover (12), if removed, by installing the ball (21), spring (20),adjusting screw (19), locknut (18), fiber washers (17), and the valve nut (16).h.Install the plug nut (14) and fiber washer (13) in the cover (12).i.Install the coupling (9) on the drive shaft (26).j.Install the adapter (6) on the motor (5) with the machine screws (7). Install the pump assembly (8) on theadapter (6), taking care to ensure that the machined surfaces of the coupling (9) and the motor (5) drive shaftmate properly. Secure the cover (9) by tightening the hexagon head capscrew (11).k.Install the pump assembly (8) with motor (5) to the motor base (4) with machine screws (1) and lockwashers(2).I.Install the grommets (3) in the motor base (4), if removed.m.The vertical position of the pump assembly (8) may be adjusted, if desired by loosening the hexagon headcapscrew (11), and rotating the pump assembly (8) on the adapter (6).n.Install the prelube pump B3 on the generator set skid base in accordance with the Operator andOrganizational Maintenance Manual.8-16
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
