Figure 6-8. Gear Pump, Exploded View

Figure 6-7. Damper Assembly, Exploded View

To avoid damage to the gear pump assembly

TM-9-6115-604-34 Generator Set Diesel Engine Driven Tactical Skid Mtd 5 Kw. 1 Phase-2 Wire 1 Phase -3 Wire 3 Phase -4 Wire 120. 120/240 and 120/208 Volts Manual
Page Navigation
216

TM 9-6115-604-34 NAVFAC P-8-633-34 1. CAPSCREW 10. GEAR 2. LOCKWASHER 11. DRIVE SHAFT 3. WASHER 12. IDLER SHAFT 4. FUEL INLET CONNECTION 13. GEAR 5. PREFORMED PACKING 14. PRESSURE VALVE 6. PIPE PLUG 15. COVER 7. HOUSING 16. COVER DOWEL 8. GASKET 17. DOWEL RING 9. BUSHING 18. GEAR PUMP ASSEMBLY Figure 6-8. Gear Pump, Exploded View (2) Inspect. See Figure 6-8. WARNING Compressed air used for cleaning or drying can create airborne particles that may enter the eyes. Pressure shall not exceed 30 psi (207 kPa). Wearing of goggles Is required to avoid Injury to personnel. (a) Clean all parts in dean diesel fuel, regular grade DF2 W-F-800, and blow dry with compressed air. (b) Inspect all threaded parts for damaged and stripped threads. Repair minor thread damage by chasing. Repair stripped holes in accordance with paragraph 2-12. Replace stripped capscrews and fittings. (c) Inspect the cover (15, Figure 6-8) for wear and scoring in gear rotation area. Replace the cover if scoring or a wear edge can be felt with the fingernail. (d) Check the bushings (9) in the cover (15). Replace a bushing if the bushing maximum inside diameter is greater than 0.5016 inch (12.741 mm). (e) Replace the cover dowels (16), or dowel ring (17), if necessary, using an arbor press. Install the dowel ring (17) so that it bottoms in the recess in the cover (15). Install the cover dowels (16) so that they will protrude slightly below the surface of the cover, and will extend through the gasket (8) into the housing (7). 6-15

Privacy Statement
Press Release
Contact