1.2.3.4.5.6.ALL SOLDERED CONNECTIONS SHALL BEIN ACCORDANCE WITH MIL-STD-454,REQUIREMENT 5.CUT INSULATION SLEEVING, FIND NO. 5,INTO 9 PIECES, .750 INCHES LONG ANDINSTALL OVER WIRES AND PINS. AFTERSOLDERING, TO THE CONNECTOR, FINDNO. 1. THEN APPLY HEAT OF 400°F FOR3-5 SEC. FOR PROPER SHRINKAGE.INSTALL STRAPS, FIND NO. 4, AT 3.00 MAXINTERVALS AND AT EACH CABLEBREAK-OUT.WIRE MARKING TO BE IN ACCORDANCEWITH MlL-W-5088 EXCEPT THAT LENGTHBETWEEN GROUPS OF NUMBERS SHALLNOT EXCEED 6 INCHES.CRIMPED TERMINALS SHALL MEET THEPERFORMANCE REQUIREMENTS OFMIL-T-7928.REFERENCES:A. CONNECTION DIAGRAM: SEE 72-2631.B. SCHEMATIC DIAGRAM: 72-2629, FOR 50/60 Hz.Figure 3-133. Static Exciter Wiring Harness, Dwg. No. 72-2628, Voltage Regulator Wiring Harness,Dwg. No. 72-2627, and Static Exciter Connection Wiring Diagram, Dwg. No. 2-2631 (Sheet 3 of 4)3-282ARMY TM 9-6115-464-34AIR FORCE 35C2-3-445-2NAVY NAVFAC P-8-624-3472-2630, FOR 400HzNOTES:
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
