A. Static Exciter Wiring Harness (Sheet 1 of 2)

Figure 3132. 400 Hz Static Exciter and Voltage Schematic Diagram, Drawing No. 72-2630

TM-9-6115-464-34 Generator Set Diesel Engine Driven Tactical Skid Mtd 15 Kw 3 Phase 4 Wire 120/208 and 240/416 Volts Manual
Page Navigation
314

ARMY TM 9-6115-464-34 AIR FORCE 35C2-3-445-2 NAVY NAVFAC P-8-624-34 NOTES: 1. 2. 3. 4. ALL SOLDERED CONNECTIONS SHALL BE 5. IN ACCORDANCE WITH MIL-STD-454, 6. REQUIREMENT 5. CUT INSULATION SLEEVING, FIND NO. 7, 7. INTO 24 PIECES, .750 INCHES LONG AND INSTALL OVER WIRES AND PINS, AFTER 8. SOLDERING, TO THE CONNECTORS, FIND NOS. 3,2, AND 1. THEN APPLY HEAT OF 400° F FOR 3-5 SEC. FOR PROPER 9. SHRINKAGE. INSTALL STRAPS, FIND NO. 9, AT APPROXIMATELY 2.5 INTERVALS AND AT EACH WIRE BREAKOUT. WIRE MARKING TO BE IN ACCORDANCE WITH MIL-W-5088 EXCEPT THAT LENGTH BETWEEN GROUPS OF NUMBERS SHALL NOT EXCEED 6 INCHES. INTERPRET DRAWING PER MIL-STD-100. CRIMPED TERMINAL SHALL MEET THE PERFORMANCE REQUIREMENTS OF MIL-T-7928. INSTALL END SEAL PLUGS, FIND NO. 8, IN UNUSED HOLES OF CONNECTORS, FIND NOS. 1,2, AND 3. REF: CONNECTION DIAGRAM 72-2631 SCHEMATIC DIAGRAM 72-2630 AND 72-2629 ALL WIRES WITHOUT TERMINAL LUGS SHALL BE STRIPPED .25 FROM THE END AND TINNED IN ACCORDANCE WITH MIL-STD-454, REQUIREMENT 5. A. Static Exciter Wiring Harness (Sheet 1 of 2) Figure 3-133. Static Exciter Wiring Harness, Dwg. No. 72–2628, Voltage Regulator Wiring Harness, Dwg. No. 72–2627, and Static Exciter Connection Wiring Diagram, Dwg. No. 2-2631 (Sheet 1 of 4) 3-280

Privacy Statement
Press Release
Contact