ARMY TM 9-6115-464-34
AIR FORCE TO 35C2-3-445-2
NAVY NAVFAC P-8-624-34
NOTES:
1.
2.
3.
4.
ALL SOLDERED CONNECTIONS SHALL BE
5. CRIMPED TERMINALS SHALL MEET THE
IN ACCORDANCE WITH MIL-STD-454,
PERFORMANCE REQUIREMENTS OF MIL-T–7928.
REQUIREMENT 5.
6. INTERPRET DRAWING PER MIL-STD-1OO.
CUT INSULATION SLEEVING (FIND #9) INTO
7. REFERENCES
38 PIECES, .750 INCHES LONG AND
a) FOR WIRING DIAGRAM, SEE DRAWING
INSTALL OVER WIRES AND PINS, AFTER
72–2205.
SOLDERING, TO THE CONNECTORS
b) FOR SCHEMATIC DIAGRAM, SEE
(FIND #2 AND #3). THEN APPLY HEAT OF
DRAWING 72–2200 AND 72-2269.
400°FOR 3-5 SEC. FOR PROPER
SHRINKAGE.
INSTALL STRAPS, FIND NO. 7 AT 3.0
MAX INTERVALS AND AT EACH CABLE
BREAK-OUT.
WIRE MARKING TO BE IN ACCORD–
ANCE WITH MIL-W-5088 EXCEPT
THAT LENGTH BETWEEN GROUPS OF
NUMBERS SHALL NOT EXCEED 6 INCHES.
Figure 3-128. 50/60 Hz Precise Relay Assembly Wiring Harness, Drawing No. 72-2242 (Sheet 1 of 2)
3-267
