ARMY TM 9-6115-464-34
AIR FORCE 35C2-3-445-2
NAVY NAVFAC P-8-624-34
NOTES:
1. ALL SOLDERED CONNECTIONS SHALL BE
IN ACCORDANCE WITH MIL-STD-454,
REQUIREMENT 5.
2. INSTALL STRAPS, FIND NO. 9, AT 3.0
MAXIMUM INTERVALS AND AT
EACH CABLE BREAK-OUT.
3. WIRE MARKING TO BE IN ACCORDANCE
WITH MIL-W-5088 EXCEPT THAT
LENGTH BETWEEN GROUPS OF
NUMBERS SHALL NOT EXCEED 6 INCHES.
4. CRIMPED TERMINALS SHALL MEET THE
PERFORMANCE REQUIREMENTS OF
MIL-T-7928.
5. INSTALL END SEAL PLUGS, FIIND NO. 2 IN
UNUSED HOLES OF
CONNECTOR, FIND NOS 1 AND 3.
6. INTERPRET DRAWING PER MIL-STD-100.
7. REFERENCES
a) FOR WIRING DIAGRAM, SEE DRAWING 72-2205.
b) FOR SCHEMATIC DIAGRAM, SEE DRAWING 72-2200 AND 72-2269.
Figure 3-93. AC Power Control Wiring Harness, Drawing No. 72-2259 (Sheet 1 of 2)
3-202