Figure 3-92.400 Hz Electric Governor System Wiring Harness Assembly

Figure 3-92. 400 Hz Electric Governor System Wiring Harness Assembly

Figure 3-93. AC Power Control Wiring Harness, Drawing No. 72-2259 (Sheet 1 of 2)

TM-9-6115-464-34 Generator Set Diesel Engine Driven Tactical Skid Mtd 15 Kw 3 Phase 4 Wire 120/208 and 240/416 Volts Manual
Page Navigation
235

ARMY TM 9-6115-464-34 AIR FORCE TO 35C2-3-445-2 NAVY NAVFAC P-8-824-34 NOTES: 1. ALL CONDUCTORS SHALL BE STRIPPED .50+ .12 AND TINNED BEFORE ASSEMBLY USING SOLDER, FIND 7. 8. 9. BAND MARKER, FIND NO. 2, SHALL “30554/8> 2005” IN ACCORDANCE WITH MIL-STD-130. FOR INTERPRETATION OF: NO 12. ELECTRICAL CONNECTIONS SHALL BE SOLDERED IN ACCORDANCE WITH MIL-STD-454. REQUIRE- MENT 5, USING SOLDER, FIND NO. 12. WIRE MARKING SHALL BE IN ACCORDANCE WITH MIL-W-5068 EXCEPT THAT INTERVALS SHALL NOT DRAWING, SEE DOD-STD-1C0 FILL COMPLETE INSIDE AREA OF CONNECTOR EXTENSION, FIND NO. 5 WITH POTTING COM- POUND. FIND NO. 15. 2. 3. 4. 5. 6. 10. CONNECTOR, FIND NO. 11, SHALL BE IN ACCORDANCE WITH MS3106R, INSERT ARRANGEMENT 105L-45. 11. SEAL UNUSED HOLES IN GROMMETS OF CONNEC- TORS, FIND NO. 1 AND 10, WITH PLUGS, FIND NO. 16. 12. THE CONNECTORS OF WIRE NUMBERS 13, 14, 15 and 21 SHALL BE TWISTED TOGETHER AND SOLDERED. THE CONNECTION SHALL BE WITH HEAT SHRUNK INSULATION SLEEVING, FIND NO. 17. THIS CONNECTION SHALL BE POSITIONED TO CLEAR THE PRINTED WIRING BOARD ASSEMBLY, FIND NO. 3, PRIOR TO POTTING IN ACCORDANCE WITH NOTE 9. EXCEED 6.00. TIEDOWN STRAPS. FIND NO. 13, SHALL BE LOCATED APPROXIMATELY 3.00 APART AND ALL BREAKOUTS. CONNECTORS FIND NO. 1,4,10, 11, SHALL BE MARKED WITH REFERENCE DESIGNATIONS SHOWN IN ACCORDANCE WITH MIL-STD-130, US- ING .25 HIGH CHARACTERS. EXTENSION, FIND NO. 5, SHALL BE MARKED “A31” IN ACCORDANCE WITH MIL-STD-130, USING .25 HIGH CHARACTERS. Figure 3-92.400 Hz Electric Governor System Wiring Harness Assembly Drawing No. 84-704 (Sheet 2 of 2) 3-201

Privacy Statement
Press Release
Contact