-ARMY TM 9-6115-34AIR FORCE TO 35C2-3-445-2NAVY NAVFAC P-8-624-34Figure 3-23. Throttle Linkage Adjustmentf. Fuel Inject Pump Bench Test.(1) General. The bench test procedure is based on the following renditions:(a) Injection lines are 3/32 inch ID by 30 inches long.(b) Fuel readings are based on fuel with a viscosity of 34-36 SSU at 100°F.(c) Fuel temperature at 110° to 115°F.(d) Nozzles, part number 12SD12, adjusted to opening pressure of 2500 psi (170 ATS).(2) Test procedure.(a)(b)Mount pump securely in diesel injector test stand using a suitable adapter. The drive adapter,usually with a ball bearing, supports the shaft. This pump must be tested with an intermediatesupport bearing. Install high pressure injection lines using new gaskets. Leave fuel line connectorscrews at pump and injection line nuts at the nozzles loose. Install fuel inlet and return lines. Installtransfer pump pressure gauge with a shutoff valve as close to the transfer pump as possible.NOTETransfer pump pressure gauge must be isolated by shutoff valve at the fuel injectionpump when checking fuel delivery and advance movement.Set counter and tachometer switches to clockwise position.-3-61
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business