ARMY TM 9-8115-484-12
AIR FORCE TO 35C2-3-445-1
NAVY NAVFAC P-8-624-12
1. Nut
2. Screw
3. Washer
4. Receptacle, slave
(g)
(h)
(i)
(j)
Figure 4-3. Slave Receptacle, Removal and Installation
Measure brush length. Replace brushes if length is 3/8 inch or less.
Use extreme care to avoid enlarging commutator slots. Equipment damage could result if
care is not observed.
Inspect starter armature commutator slots for thrown solder. Remove any found with a narrow blunt
instrument.
Check bronze bushing in commmutator end frame and armature shaft for deep wear patterns, scoring,
or other damage. Replace starter assembly if damage exists.
Check brusholders and brush support for corrosion, cracks, breaks, and other damage. Replace any
defective parks.
4-22
