TM5-6115-634-14&P
NAVFAC P-8-647-14&P
T0-35C2-3-445-14
TM-6115-14&P/1
4-28 REPLACE AIR CLEANER HOUSING (cont)
4.
AIR CLEANER HOUSING.
a.
Remove cable clamp (8) from air
cleaner housing (3).
b.
Remove the air cleaner housing
(3) by removing four screws
(9), lockwashers (10) and
hex nuts (11).
INSTALLATION
1.
INSTALL AIR CLEANER HOUSING.
a.
Position air cleaner housing
(3) mounting brackets, so
mounting holes are in line
with mounting holes in the
center support section (12).
b.
Install the air cleaner
housing (3), by installing
four screws (9), lockwashers
(10) and hex nuts (11).
c.
Install cable clamp (8) on
air cleaner housing (3).
2.
INSTALL SWITCH PRESSURE.
a.
Install the pressure switch
(7) into its threaded hole.
b.
Connect cannon plug (6) to
the pressure switch (7).
3.
INSTALL AIR BREATHER HOSE.
a.
Place the spring clamp (5) onto
the air breather hose (4),
approximately one-inch from the
end.
b.
Fit the air breather hose (4)
onto the air inlet and slide
the spring clamp (5) over the
inlet to secure the hose.
4-41
