CHAPTER 6 MAINTENANCE OF THE SUPPORT FRAME ASSEMBLY

TM-5-6115-593-34 Generator Set Diesel Engine Driven Tactical Skid Mtd. 600 Kw 3 Phase 4 Wire 120/208 and 240/416 Volts Manual
Page Navigation
97

TM5-6115-593-34 NAVFAC P-8-631-34 TO-35C2-3-463-2 CHAPTER 6 MAINTENANCE OF THE SUPPORT FRAME ASSEMBLY 6-1. GENERAL. The support frame assembly (figure 6- 1) is mounted directly on the generator set base assembly. It provides support for major components of the generator set, as well as providing a support for the optional housing kit. It is comprised of front, center, and rear support frames held together by tie bars. 6-2. REPLACEMENT. Removal and replacement of support frame assembly members, are as follows: NOTE If generator set had a housing kit, mufflers would be partially removed prior to removing the housing kit. a. Remove housing kit, refer to Chapter 15. b. Remove the AC-DC control box, external power box, control cubicle and reconnection box (see Chapter 2). c. Partially disassemble the air-cleaner and muffler assemblies in order to dismantle the support frame. The air-cleaner bracket bolts mounted on the top center support frame (5, figure 6-1) must be removed. Also, remove bolts supporting the mufflers to the silencer frame tie bar assembly (13), and remove mufflers. d. Frame supports (4, 5, 6 11, and 12) are removed by removing screws (1), nuts (3), and washers (2). e. Remove silencer frame tie bar assembly (13) as a complete unit. WARNING SILENCER FRAME ASSEMBLY IS HEAVY. BE SURE TO PROVIDE ADEQUATE SUPPORT. f. Support frames (uprights) (21, 22, 23, 24, 25, and 26) are mounted to base assembly with screws (18), nuts (20) and washers (19). NOTE The bar assembly (7) must be removed before removing rear support frames (25 and 26). g. Remove folding step (17) from center right hand support frame (24) by removing screw (14), nuts (16), and washers (15). 6-1

Privacy Statement
Press Release
Contact