Figure 5-4. Actuator Control Relay Assembly

Table 5-7. OPERATOR/CREW PREVENTIVE MAINTENANCE CHECKS AND SERVICES, HOUSING KIT

Figure 5-5. Housing Kit, Installed on Generator Set

TM-5-6115-593-12 Power Plant Utility (MUST) Gas Turbine Engine Driven (AMERTECH Corp Model APP-1) Manual
Page Navigation
247

TM 5-6115-593-12 TO 35C2-3-463-1 (3) If a break in the wire is inaccessible within the wiring harness, disconnect it at both ends and tape both ends. Lace a new lead of the same gauge and insulation outside the harness and connect it to the proper terminals or pins. Properly tag both ends of all replacement wires. d. Replacement. (1) Weather stripping. If weather stripping is damaged, rotten or defective, remove by peeling stripping off the panel or access door. Lightly scrape metal to remove any pieces of stripping which remain. Install fresh weather stripping by removing backing from a small (six-inch) section of the new stripping and pressing into place. Peel off additional backing as necessary, and continue to press stripping into place until completed. NOTE Do not "patch" one section of stripping on any component panel. Replace the all weather stripping around any panel. (2) Harness assembly. If 30 percent of the harness wires are defective, refer to next higher level of maintenance for replacement. Figure 5-4. Actuator Control Relay Assembly 5-23

Privacy Statement
Press Release
Contact