TM 5-6115-593-12 TO 35C2-3-463-1 Table 5-1.   OPERATOR/CREW PREVENTIVE MAINTENANCE CHECKS AND SERVICES, REMOTE CONTROL MODULE. NOTE:  Within designated interval, these checks are to be performed in the order listed. B-Before    A-After D-During Item INTERVAL ITEMS TO BE PROCEDURES CHECK FOR AND HAVE REPAIRED EQUIPMENT IS NOT READY/ No. B D A INSPECTED OR ADJUSTED AS NECESSARY AVAILABLE IF: 1 o Remote Control Module Inspect  controls,  gauges,  lamps  and instruments  daily  for  damage,  loose mounting or loose connections. 5-6. OPERATOR/CREW TROUBLESHOOTING. Table 5-2 contains troubleshooting information for use in correcting  operating  troubles  which  may  develop  in  the generator    set    when    used    with    the    remote    control module.  Each malfunction is followed by a list of tests or   inspections   which   will   help   to   determine   probable causes and corrective actions to take.  Perform the tests or inspections and corrective actions in the order listed. Any trouble beyond the scope of crew level maintenance   should   be   referred   to   the   next   higher (organizational) level of maintenance. NOTE Before referring to table 5-2, be sure that all applicable checks have been performed. 5-7.OPERATOR/CREW MAINTENANCE OF THE REMOTE     CONTROL     MODULE.          This     paragraph includes    instructions    to    assist    the    operator/crew    in maintaining   the   remote   control   module.      If,   during inspections,  defective  components  are  noted,  refer  to next   higher   level   of   maintenance   for   replacement   or repair. a. Inspection.      Inspect   components   on   the   front panel,  inside  the  enclosure,  and  on  the  mounting  plate as follows: (1)   Inspect all gauges, switches, and instruments  on  front  panel  for  cracking  or damage, loose mounting or loose connections. (2)   Inspect  the  telephone  jack  (30,  figure  2-14) for    damage,    loose    mounting,    or    loose connections. (3)   Inspect the panel lamps (19, figure 2-14) for loose mounting or loose connections. (4)   Inspect    transformer    (29,    figure    5-2)    for cracking    or    damage,    loose    mounting    or loose connections. b.     Replacement. (1)   Replace defective bulbs in lamp assemblies. (2)   Replace defective telephone jack as follows: (a)   Tag and remove wires connected to the jack. (b)   Remove   the   hex   nut   and   flatwasher attaching jack to panel, and remove jack. (c)   Install  jack  and  secure   with  flatwasher and hex nut. (d)   Connect wires and remove wire tags. 5-8. ORGANIZATIONAL TROUBLESHOOTING. Table     5-3     provides     information     for     locating     and correcting  operating  troubles  which  may  develop  in  the generator    set    when    used    with    the    remote    control module.  Each malfunction is followed by a list of tests or   inspections   which   will   help   to   determine   probable causes and corrective actions to take.  Perform the tests or inspections and corrective actions in the order listed. Any trouble beyond the scope of 5-3