TM 5-6115-593-12TO 35C2-3-463-1(3) Check hose for cracking or leakage.(4) Loosen clamps (24) holding duct hose (25).(5) Check inside hose for accumulation of dirt.(6) Check hose for cracking or leakage.(7) If hoses are damaged, then replace as follows. If no damage is found tighten all clamps (24) to securehoses.a. Replacement.(1) Remove duct hose (25) by sliding it off valve (27) and away from air cleaner (29).(2) Remove adapter hose (26) by sliding it off valve (27) and away from turbocharger.(3) Install adapter hose (26) by sliding it over valve (27) and onto turbocharger. Secure with clamps (24).(4) Install duct hose (25) by sliding it over valve (27) and onto air cleaner (29). Secure with clamps (24).Section XIV. MAINTENANCE OF TOOL BOX ASSEMBLY4-45. TOOL BOX ASSEMBLY. (See figure 4-24)a. Replacement. The tool box assembly is mounted on the right side of the main frame assembly next to theengine.(1)Removal. Remove two screws (1), washers (2), lock- washers (3), and nuts (4), at the bottom of thetool box supporting it to the frame.(2) Installation. Install tool box in place on frame, line up two holes at bottom of tool box with holes inframe, and secure with two screws (1), washers (2), lockwashers (3), and nuts (4).b. Repair.(1) Replace latches (11) by removing screws (9) and nuts (10).(2)If box is dented, straighten box. If any signs of rust or corrosion, sand and clean area and repaint toolbox.4-74
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
