Reassembly. - TM-5-6115-585-34

Figure 8-3. Generator Frame Assembly Winding Data

TM-5-6115-585-34 Generator Set Diesel Engine Driven Tactical Skid Mtd 5 KW 1 Phase 2 Wire 1 Phase-3 Wire 3 Phase-4 Wire 120 120/240 and 120/208 Volts Manual
Page Navigation
124

TM5-6115-585-34 NAVFAC P-8-262-12 TO-35C2-3-455-2 TM-05684C/05685B-34 (5) Mount coupling disc and fan assembly to the rotor assembly (52, MEP-113A, or 52A, MEP-112A) using screw (24) lock plate (25) and retaining ring (26). Bend lock tabs flat against head of screw (24). (6) Mount exciter stator (17) to end bell (16) using screws (14) and lockwashers (15). (7) Place “O” ring (12) into end bell bearing housing, attach terminal board (20) to the exciter stator using screws (19) and nuts (18). Connect pre- viously tagged and removed harness wire terminals. (8) Mount end bell assembly (13) to the stator assembly (53) using screw (10) and lockwashers (11). (9) Install bearing retainer (33, MEP-003A, or 33A, ME-112A) and secure to end bell (16) with lock- washer (9) and screw (8). (10) Mount end bell cover (7) using screws (5) and lockwashers (6). (11) Mount screen (4) to generator, secure with screw (l), nut (2) and lockwasher (3). k. Test After Assembly. Rotate the generator rotor shaft to be certain it rotates freely, that bear- ings are smooth and rotor does not rub against stator. 1. Installation. Refer to paragraph 2-10 for mounting of the generator. m. Generator Winding Data. (1) Generator frame assembly (see figure 8-3). (2) Generator rotor (see figure 8-5). (3) Exciter rotor assembly (see figure 8-4). 8-6 Change 2

Privacy Statement
Press Release
Contact