TM-5-6115-585-12

TM-5-6115-585-12 Generator Set Diesel Engine Driven Tactical Skid Mtd 5 KW 1 Phase 2 Wire 1 Phase-3 Wire 3 Phase-4 Wire 120 120/240 and 120/208 Volts Manual
Page Navigation
46

TM 5-6115-585-12 NAVFAC P-8-623-12 TO-35C2-3-455-1 TM-05684C/05685B-12 ( 3 ) F u e l P u m p A s s e m b l i e s ( T h r e e ) ( s e e f i g u re 3-14). Inspect fuel pumps (1) for dents or other phys- ical damage. Check for leaks especially around hose assembly fittings (2). Check that fuel pumps are se- curely a t t a c h e d t o m o u n t i n g b r a c k e t ( 3 ) a n d t h a t mounting bracket is securely attached to bracket sup- port on skid-base. Inspect electrical leads to fuel pumps to see that wires and connectors are not b r o k e n , f r a y e d , o r d a m a g e d . C h e c k t h a t c o n n e c t o rs are tightly connected. Check that cap (4) on auxiliary fuel pump inlet is securely in place when unit is not being run from auxiliary fuel supply. (4) Fuel Hoses. Inspect fuel hoses (2, 3 and 4, figure 3-13) for leaks or physical damage. Check to see that fuel hose fittings are securely tightened in p l a c e . b. Service. (1) Fuel Filter Assemblies (see figure 3-13). Daily before and after operation, open drain valves (1) and drain water and sediment from assemblies. (2) Fuel Strainer Assembly. Daily, before and after operation, open drain valves (1) and drain water and sedi- ment from strainer assembly (11). Figure 3-14. Fuel Pump Assembly Figure 3-15. Control Cubicle Support Assembly 3-21. C O N T R O L C U B I C L E S U P P O R T A S S E M B L Y, S P E E D C O N T R O L A N D E N G I N E C O N T R O L WIRING HARNESS. a . I n s p e c t. ( 1 ) V i b r a t i o n M o u n t s ( F o u r ) ( s e e f i g u r e 3 - 1 5 ) . I n s p e c t v i b r a t i o n m o u n t s f o r d e t e r i o r a t i o n o r p h y s i- cal damage. Inspect mounts to see that they are free o f d i r t , f u e l , o r o i l . C h e c k t o s e e t h a t m o u n t s a r e securely attached to control cubicle support on skid- b a s e . I f m o u n t s a r e f a u l t y , r e f e r t o h i g h e r l e v e l of m a i n t e n a n c e. (2) Engine Control Wiring Harness Assembly. On ASK equipped generators, open or remove all access doors. Inspect wiring harness for broken or frayed wires. Check for wires with damaged or deteriorated insulation. Check that all connectors and terminals are clean and tight. (3) Speed Control Assembly (see figure 3-16). On ASK equipped generators, lift motor speed control flap. Inspect to see that speed control is firmly attached to unit. Check that speed control moves in and out freely. If speed control is loose, refer to higher level maintenance. 3-20 C h a n g e 8

Privacy Statement
Press Release
Contact